Siemens ET 200pro - Mounting the Electronic Module

Mounting
3.5 Mounting the Electronic Module
ET 200pro distributed I/O system
56 Operating Instructions, 03/2013, A5E00335544-08
3.5
Mounting the Electronic Module
Introduction
The electronic module determines the function of the input and output channels. The
connection module is mounted onto the electronic module.
Requirements
● The interface module is mounted onto the rack.
● All electronic modules must be installed to the right side of the interface module.
● The interface module is inserted into the relevant bus module (as delivered).
● The connection module may not be installed when you move the electronic module to a
position further on the left side.