ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
43
Requirements
Preassembling ET 200pro modules
The ET 200pro modules can be preassembled on a narrow or wide rack version before
installing the rack on site.
An ET 200pro can be mounted in any position.
Note
If you configure the ET
200pro Distributed I/O System with the ET 200pro FC frequency
converter, observe the restrictions regarding the mounting position. Additional information
can be found in the ET
200pro FC FC
http://support.automation.siemens.com/WW/view/en/28561828) operating instructions.
To Next Page
Loading...
