Siemens ET 200pro - Preparing PROFIBUS Hybrid Cables for the Connection at CM IM DP Direct

Connection
4.5 Connecting the interface module to a CM IM DP Direct connection module
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
81
See also
Mounting the Interface Module (Page 53)
Connecting PROFIBUS DP (Page 84)
Connecting the supply voltages (Page 85)
4.5.3
Preparing PROFIBUS Hybrid Cables for the Connection at CM IM DP Direct
PROFIBUS Hybrid cables
In addition to the lines for load voltage supply 1L+, the PROFIBUS Hybrid cables contain the
shielded PROFIBUS DP lines. The 6-wire PROFIBUS Hybrid cables also include the lines
for supply voltage 2L+. Versions available:
● PB Hybrid Standard Cable, 4-wire
● PB Hybrid Standard Cable, 4-wire, suitable for cable carriers
● PROFIBUS ECOFAST Hybrid Cable, 6-wire
● PROFIBUS ECOFAST Hybrid Cable GP, 6-wire, suitable for cable carriers
①
Conductor for supply voltage
②
Filler
③
Conductor for PROFIBUS DP
④
Shielding braid
⑤
Shielding film