Siemens ET 200pro - Overview of Parameters of Pneumatic Interface Module

Pneumatic interface modules
16.3 Overview of parameters of pneumatic interface module
ET 200pro distributed I/O system
458 Operating Instructions, 03/2013, A5E00335544-08
Technical specifications
Data for selection of valve terminal
1
Medium Compressed air: Filtered (40 µm); oiled
(oil: VG 32); not oiled/vacuum
Pressure range
3 bar to 8 bar
Nominal flow rate
800 l/min
Valve switchover times
• On, by
24 ms
• Off
30 ms
Current consumption per valve
32 mA
1
For detailed information on valve terminals, refer to the FESTO documentation on the valve
terminals.
16.3
Overview of parameters of pneumatic interface module
Parameters of the power module
Parameters
Value range
Default
Scope
Diagnostics missing load
voltage L+
• Disable
• Enable
Disable Module