Siemens ET 200pro - Rack

Mounting
3.2 Rack
ET 200pro distributed I/O system
44 Operating Instructions, 03/2013, A5E00335544-08
3.2
Rack
3.2.1
Rack
Rack versions
The following rack types are available for the ET 200pro: narrow, wide, compact-narrow, and
compact-wide. The modules can be preassembled on the narrow and wide rack versions.
Versions
Properties
Length
Rack, narrow
• For interface / power / electronic modules
• Module preassembly is possible
• 500 mm long, with
mounting holes
• 1000 mm long, with
mounting holes
• 2000 mm long, without
mounting holes
Rack, wide
• For interface/power/electronic modules,
motor starters, and frequency converters
• Pre-assembly of modules, motor starters,
and frequency converters possible
Rack, compact-
narrow
• For interface / power / electronic modules
Rack, compact-wide
• For interface/power/electronic modules,
motor starters, and frequency converters
Vibration resistance
In order to achieve the guaranteed vibration resistance of all ET 200pro modules, always use
all
mounting holes to mount the rack.
Rack with a length of 2000 mm
Cut the 2000 mm rack to suit your requirements, and drill mounting holes for the M8 screws.
In order to achieve the guaranteed vibration resistance of all ET 200pro modules, position
the first holes at a distance of 12 mm to both ends, and the intermediate holes at an even
pitch of max. 200 mm.