Siemens ET 200pro - 11 Connection Modules; Connection Modules for Interface Modules with PROFIBUS DP; Connection Module CM IM DP Direct for Interface Modules

ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
249
Connection modules
11
11.1
Connection modules for interface modules with PROFIBUS DP
11.1.1
Connection module CM IM DP Direct for interface modules
Order number
6ES7194-4AC00-0AA0
Properties
Properties of the CM IM DP Direct connection module:
● Can be plugged in and attached with screws to the interface module
● The 1L+ and 2L+ supply voltages are connected via screw terminals, and PROFIBUS DP
via insulation displacement terminals.
● You can loop through the power supplies and PROFIBUS DP using additional terminals.
● PROFIBUS DP address 1 to 125 can be set by means of a DIP switch
● Switched terminating resistor for PROFIBUS DP, set by means of DIP switch
● 6 labels
Pin assignment
For information on the pin assignment of CM IM DP Direct, refer to the section Interface
modules
.