Siemens ET 200pro - Installing the Pneumatic Interface Module

Mounting
3.6 Installing the pneumatic interface module
ET 200pro distributed I/O system
58 Operating Instructions, 03/2013, A5E00335544-08
3.6
Installing the pneumatic interface module
Introduction
The pneumatic interface module is first mounted onto the rack. The FESTO valve terminal is
then fixed with screws to the connection plate. This unit is then mounted on the pneumatic
interface module.
①
FESTO valve terminal with sponge-rubber seal (on the bottom)
②
Connection plate
③
Pneumatic interface module
④
Bus module
⑤
Position of the O-rings for sealing
Figure 3-8 Installing the pneumatic interface module