Siemens ET 200pro - CM IM PN PP FO Connection Module for Interface Modules

Connection modules
11.2 Connection modules for the interface module with PROFINET IO
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
259
11.2.3
CM IM PN PP FO connection module for interface modules
Order number
6ES7194-4AG00-0AA0
Properties
The CM IM PN PP FO connection module has the following properties:
● Can be plugged in and attached with screws to the interface module
● Connecting of 1L+ and 2L+ supply voltages using push-pull cable connectors
● Connecting of PROFINET IO using push-pull cable connectors for SC RJ (fiber-optic
cable)
● The supply voltages and PROFINET IO can be looped through using additional sockets.
● 4 labels
Pin assignment
For information on the pin assignment of CM IM PN PP FO, refer to the section Interface
modules
.
Block diagram
①
Connections for push-pull cable connectors: Encoder/electronic supply, load voltage supply
②
Connections for push-pull cable connectors: SC RJ for PROFINET IO
Figure 11-3 CM IM PN PP FO connection module