Interface modules
12.1 Interface modules for PROFIBUS DP
ET 200pro distributed I/O system
294 Operating Instructions, 03/2013, A5E00335544-08
IM 154-2 DP High Feature interface module
Order number
6ES7154-2AA01-0AB0
The IM 154-2 DP High Feature interface module has the following properties:
● The interface module is installed on the bus module when supplied.
● The module connects the ET 200pro to PROFIBUS DP by means of the connection
module.
● The module prepares the data for the connected electronic modules.
● The module supplies the ET 200pro via the connection module with the 1L+
encoder/electronic supply and the 2L+ load voltage supply.
● The PROFIBUS DP address of ET 200pro can be set by means of the connection
module.
● The connection module can be used to activate/deactivate the terminating resistor of
PROFIBUS DP.
● IM 154-2 DP High Feature has a maximum address space of 244 byte for inputs, and
244 byte for outputs.
● Operation as DPV0 slave
● Operation as DPV1 slave
– Diagnostic interrupts
– Hardware interrupts
– Swapping interrupts
● IM 154-2 DP High Feature supports operation with up to 16 electronic modules.
● Updating the interface module firmware
● Support of fail-safe modules
● Operation as DPV1 slave on Y Link
● Option handling
● Integrated power module for the 2L+ load voltage supply of ET 200pro
Compatibility with the predecessor module
The IM 154-2 DP interface module with order number 6ES7154-2AA01-0AB0 is compatible
with the predecessor module with order number 6ES7154-2AA00-0AB0.
To Next Page
Loading...
