Siemens ET 200pro - Connecting the Power Module with the CM PM-E ECOFAST Connection Module

Connection
4.13 Connecting the Power Module with the CM PM-E ECOFAST Connection Module
ET 200pro distributed I/O system
132 Operating Instructions, 03/2013, A5E00335544-08
See also
PM-E power module (Page 319)
4.13
Connecting the Power Module with the CM PM-E ECOFAST
Connection Module
Introduction
You connect the load voltage supply 2L+ to the CM PM ECOFAST connection module using
the ECOFAST cable connector X01.
Requirements
● The power module and bus module are mounted on the rack.
Required tools
Screwdriver, stripping and crimp tool for wiring the ECOFAST cable connector, if you are
fabricating your own cables.
Required accessories
● PROFIBUS ECOFAST Hybrid Cable, preassembled at both ends with ECOFAST Hybrid
Plug 180. The patch cable is available in various lengths.
● If you are fabricating your own cables:
– PROFIBUS ECOFAST hybrid cable, unassembled
– PROFIBUS ECOFAST Hybrid Plug 180 (ECOFAST Cu) with Hanbrid connector
– PROFIBUS ECOFAST Hybrid Plug, angled, (ECOFAST Cu) with Hanbrid connector