Siemens ET 200pro - Configuring by Means of GSD File

Configuring
5.1 PROFIBUS DP
ET 200pro distributed I/O system
140 Operating Instructions, 03/2013, A5E00335544-08
5.1.2
Configuring by Means of GSD File
Introduction
The GSD file allows you to configure ET 200pro using a (previous) STEP 7 version,
COM PROFIBUS, or other software. For this purpose, the GSD file must be installed in the
configuration software beforehand.
Requirements
You require a GSD file, available for download from the Internet at:
GSD file (http://support.automation.siemens.com
)
● Interface module IM 154-1 DP:
– GSD file SI018118.GSG for 6ES7154-1AA01-0AB0
– GSD file SIEM8118.GSG for 6ES7154-1AA00-0AB0
● Interface module IM 154-2 DP High Feature:
– GSD file SI018119.GSG for 6ES7154-2AA01-0AB0
– GSD file SIEM8119.GSG for 6ES7154-2AA00-0AB0
Configuring ET 200pro on PROFIBUS DP in STEP 7
1. Start STEP 7, then select
Options > Install New GSD File
in HW Config.
2. Select the GSD file to install from the next dialog box, then confirm with OK. Result:
ET 200pro appears in the PROFIBUS DP folder of the hardware catalog.
3. The further procedure is the same as in Configuring in STEP 7 (Page 139).