Siemens ET 200pro - Mounting the Interface Module

Mounting
3.3 Mounting the Interface Module
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
53
3.3
Mounting the Interface Module
Introduction
The interface module interconnects ET 200pro with PROFIBUS DP/ PROFINET IO and
supplies power to the electronic modules.
Requirements
● Interface modules for PROFIBUS DP
– The terminating module is removed from the interface module.
– The rack has been mounted.
● Interface module for PROFINET IO
– The terminating module is removed from the interface module.
– The rack has been mounted.
Required tools
Cross-tip screwdriver, size 2