Siemens ET 200pro - Replacing Labeling and Module Identification Labels

Mounting
3.8 Replacing Labeling and Module Identification Labels
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
63
3.8
Replacing Labeling and Module Identification Labels
Introduction
Use the module tags to identify the modules, and the labels to identify their channels and
connections. The modules are supplied with the labels clipped on. Replacement labels are
available on order.
Module tags in color
You may use module tags to identify the module class. The tags are available in blue, green,
white and red.
Required tools
Screwdriver, size 2.5 mm to 4 mm
Procedure
1. Push the screwdriver into the small opening of the label, and then lever it out.
2. Use your finger to press the new label into the holder of the module.
①
Module label
②
Labels
Figure 3-12 Replacing labels