Siemens ET 200pro - Digital electronic module 4 DO DC 24 V;2.0 A High Feature (6 ES7142-4 BD00-0 AB0)

Digital electronic modules
14.5 Digital electronic module 4 DO DC 24V/2.0A High Feature (6ES7142-4BD00-0AB0)
ET 200pro distributed I/O system
350 Operating Instructions, 03/2013, A5E00335544-08
14.5
Digital electronic module 4 DO DC 24V/2.0A High Feature
(6ES7142-4BD00-0AB0)
Order number
6ES7142-4BD00-0AB0
Properties
● Digital electronic module with four outputs
● Output current per output 2 A
● Rated load voltage 24 V DC
● Suitable for solenoid valves, DC contactors and indicator lights
● "Short-circuit outputs to M" diagnostics for each channel
● "Short-circuit outputs to P" diagnostics for each channel
● "Wire break at outputs" diagnostics for each channel
● "Missing load voltage" diagnostics for each module
● Configurable substitute value
Note
The digital outputs at DQ
0
to DQ
3
(rated load voltage 2L+) can be switched off for safety-
related operation.
More detailed information is available in the Appendix in the chapter
Fail-safe
disconnection of ET
200pro standard output modules (Page 524).
Pin assignment of connection modules CM IO 4 x M12 and CM IO 4 x M12P
The table below shows the pin assignment of the 4 DO DC 24V/2.0A High Feature on the
CM IO 4 x M12 and CM IO 4 x M12P connection modules.
View of circular connector
Terminal
Assignment X1 to X4
1
Not assigned
2
Not assigned
3
Ground for load voltage supply 2M
4 Output signal DQ
0
: Connector X1
Output signal DQ
1
: Connector X2
Output signal DQ
2
: Connector X3
Output signal DQ
3
: Connector X4
5
Functional earth (FE)
Connectors X5 to X8 are not assigned