Siemens ET 200pro - Profinet Io; Commissioning ET 200 Pro

Commissioning
6.2 PROFINET IO
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
155
6.2
PROFINET IO
6.2.1
Commissioning ET 200pro
Introduction
You commission the automation system according to the relevant plant configuration. The
section below describes the procedure of commissioning the ET 200pro connected to an
IO controller.
Requirements of ET 200pro on PROFINET IO
Actions
Reference
ET 200pro is mounted
Chapter Mounting
ET 200pro is wired
Chapter Wiring
The SIMATIC Micro Memory Card is inserted
Chapter Service and maintenance
Assigning device names to the I/O device
Chapter Configuring
ET 200pro is configured
Chapter Configuring
Supply voltage to the I/O controller is switched on
I/O controller manual
I/O controller is in RUN
I/O controller manual
Commissioning ET 200pro
1. Switch on the electronic / encoder supply 1L+ for ET 200pro.
2. Switch on the load voltage supply/ies 2L+.
Note
Changes to the backplane bus
Always switch off/on power to the electronic / encoder supply 1L+ before you modify the
backplane bus configuration (number of modules, removal of the terminating module).
See also
Mounting the Interface Module (Page 53)
Configuring by Means of GSD File (Page 148)
Configuring in STEP 7 (Page 147)