Siemens ET 200pro - Page 185

Functions
8.1 PROFIBUS DP
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
185
Identification data
Table 8- 5 Identification data
Identification data
Access
Default
Description
Identification data 0: Index 1 (data record 231)
MANUFACTUREROR_ID Read (2 byte) 2A hex (=42 dec) The name of the manufacturer is stored
here. (42 dec = SIEMENS AG)
ORDER_ID Read (20 byte) depends on the
module
Order number of the module
SERIAL_NUMBER Read (16 byte) depends on the
module
Electronic rating plate
HARDWARE_REVISION Read (2 byte) depends on the
module
Electronic rating plate
SOFTWARE_REVISION Read (4 bytes) Firmware Indicates the firmware version of the
module.
REVISIONS_COUNTER Read (2 byte) - Provides information on parameter
modifications on the module.
PROFILE_ID
Read (2 byte)
F600 hex
Generic device on interface modules
PROFILE_SPECIFIC_
TYPE
Read (2 byte) 0005 hex on interface modules
IM_VERSION Read (2 byte) 0101 hex Provides information on the ID data version
(0101 hex = version 1.1)
IM_SUPPORTED Read (2 byte) 000E hex Provides information on existing
identification data (index 2 to 4)
Maintenance1: Index 2 (data record 232)
TAG_FUNCTION Read/write
(32 byte)
- Enter a identifier here that is unique plant-
wide.
TAG_LOCATION Read/write
(22 byte)
- Define the installation location of the
module.
Maintenance2: Index 3 (data record 233)
INSTALLATION_DATE Read/write
(16 byte)
- Enter the installation date of the module
here.
RESERVED Read/write
(38 byte)
- Reserved
Maintenance3: Index 4 (data record 234)
DESCRIPTOR Read/write
(54 byte)
- Enter a comment describing the module.