Siemens ET 200pro - Page 311

Interface modules
12.2 Interface modules for PROFINET IO
ET 200pro distributed I/O system
Operating Instructions, 03/2013, A5E00335544-08
311
Compatibility with the controller
Note
Firmware version of controller used
To use the IM 154
-4 PN High Feature interface module (6ES7154-4AB10-0AB0) on a
controller, the controller must be operated with one of the firmware versions
listed in the
table below.
The most recent firmware versions are available from your Siemens representative or from
the Internet (
http://www.siemens.com/automation/service&support).
The following firmware versions are required for operating non-failsafe I/O modules on the
IM 154-4 PN High Feature interface module:
CPU
CP
SOFTNET
PNIO
Controller 315-2 PN/DP
317-2 PN/DP
IM 154-8
PN/DP CPU
443-1
343-1
SIMATIC
NET-CD
6GK7343-
1EX21..
6GK7343-
1GX21..
Firmware version
≥ V2.3.2
≥ V2.2
≥ V1.1
≥ V1.0
V6.3 Hotfix 1
The following firmware versions are required for operating failsafe I/O modules on the
IM 154-4 PN High Feature interface module:
CPU
CP
Controller 315F-2 PN/DP
317F-2 PN/DP
IM 154-8 PN/DP F-CPU
416-F 443-1
Firmware version ≥ V2.3.3 ≥ V4.1 ≥ V2.3