Mounting
3.6 Installing the pneumatic interface module
ET 200pro distributed I/O system
60 Operating Instructions, 03/2013, A5E00335544-08
Mounting the pneumatic interface module on the rack
1. Remove the connection plate from the pneumatic interface module.
2. Place the pneumatic interface module on the rack, then push it on until it engages.
3. Slide the pneumatic interface module to the right until it snaps into place on the previous
module.
Figure 3-9 Mounting the pneumatic interface module on the rack
Note
The pneumatic interface module may not become skewed when you move it.
An increased force has to be
exercised to get the module to snap into the previous
module and achieve a tight seal.
To Next Page
Loading...
