Siemens FT724 - Standby Visibility; Expanded Visibility

System functions
Visibility
6
119 |
184
Building Technologies
A6V10211076_i_en_
--
Fire Safety
2015
-
12
-
15
6.9.1 Standby visibility
The ↑ 'Station' with the 'PMI standby visibility' configuration monitors one or more
other 'Stations', or a ↑ management station in the configured ↑ visibility.
● When the fire detection installation is in normal operating condition, 'PMI
standby visibility' is deactivated. The 'Station' configured in this way and the
display are then in quiescent condition.
● If a monitored 'Station' fails or if the connection to a monitored 'Station' is
interrupted, the configured 'PMI standby visibility' becomes active and the fire
detection installation can be operated in the configured visibility via this 'Station'
exactly as was previously the case with the failed 'Station'.
In addit
ion to '
PMI standby visibility
', '
PMI expanded visibility
' can also be
configured for a ↑ 'Station'.
See also
1 Deactivating standby [➙ 60]
1 Expanded visibility [➙ 119]
6.9.2 Expanded visibility
If configured, you can use a command to activate 'PMI expanded visibility' for a
↑ 'Station' and this gives you the configured ↑ visibility.
For a 'Station' with 'PMI standby visibility', 'PMI expanded visibility' can also be
configured.
The 'PMI expanded visibility' configuration is however also available regardless of
'PMI standby visibility'.
The '
PMI expanded visibility
' function can be configured with dependencies.
Possible dependencies
● 'PMI expanded visibility' can only be activated if a monitored 'Station' fails.
See also
1 Activating / deactivating expanded visibility [➙ 61]