5
90 | 184
↑ Polling the RT counter
1. Press 'Functions' > 'All functions' in the main menu.
The 'Select element category' window is open.
2. Select the 'RT control' element category.
The 'Enter address' window is open.
3. Press <ok> without entering an address.
A list with all elements of the 'RT' type is open.
4. Select an element and press <softkey 1> 'Execute commands'.
The 'Select command' window is open.
5. Select the 'Poll RT counter' command.
The number of remote transmissions is shown.
Displaying the Counter control
The ↑ pre-configuration of the 'Counter control' parts list is country-specific.
1. Press 'Functions' > 'Information' in the main menu.
2. Select that 'Counter control' is displayed.
3. All results for the configured range for 'Counter control' are displayed.
5.14.2 Polling the IP address of the 'Station'
ϖ The 'Station' is networked.
1. Select 'Main menu' > 'Topology' > 'Hardware tree'.
2. Highlight the 'Station'.
3. Press the 'MoreOptions' softkey.
4. Select 'Show details'.
The IP address is displayed in the 'Network' section.
To Next Page
Loading...
Need help?
General
