Siemens FT724 User Manual

A
bout this document
Applicable documents
1
9 |
184
Building Technologies
A6V10211076_i_en_
--
Fire Safety
2015
-
12
-
15
1 About this document
Goal and purpose
This document describes the operation of fire control panels and fire terminals in
the fire detection system FS720. The reader shall understand the structure of a fire
detection installation, the PMI setup and the functions in the overall system. This
understanding makes an adequate behaviour possible in the event of fire or fault.
Scope
The document applies to the fire control panels and the fire terminal of type Fx72x,
introduction package IP6.
Target groups
The information in this document is intended for the following target groups:
Target group Activity Qualification
Operating personnel
● Carries out procedures to correctly
operate the product.
● No particular basic training is
needed.
● Has been instructed by the
commissioning personnel.
Commissioning personnel
● Configure the product at the place
of installation according to
customer-specific requirements.
● Check the product operability and
release the product for use by the
operator.
● Searches for and corrects
malfunctions.
● Has obtained suitable specialist
training for the function and for the
products.
● Has attended the training courses
for commissioning personnel.
Maintenance personnel ● Carries out all maintenance work.
● Checks that the products are in
perfect working order.
● Searches for and corrects
malfunctions.
● Has obtained suitable specialist
training for the function and for the
products.
Source language and reference document
● The source/original language of this document is German (de).
● The reference version of this document is the international version in English.
The international version is not localized.
Document identification
The document ID is structured as follows:
ID code Examples
ID_ModificationIndex_Language_COUNTRY
-- = multilingual or international
A6V10215123_a_de_DE
A6V10215123_a_en_--
A6V10315123_a_--_--
Date format
The date format in the document corresponds to the recommendation of
international standard ISO 8601 (format YYYY-MM-DD).

Siemens FT724 Specifications

General

Brand	Siemens
Model	FT724
Category	Control Panel
Language	English