Siemens FT724 User Manual

Operation functions
Cerberus Remote operation modes
4
38 | 184
Building Technologies
A6V10211076_i_en_
--
Fire Safety
2015
-
12
-
15
4.7 Cerberus Remote operation modes
Cerberus-Remote has the following operation modes:
● 'Limited access (view only)'
● 'Full access (view/operation)'
For both operation modes, an authorization must be configured on the ↑ 'Station'.
In addition, a ↑ license key must be installed. The license key must support the
Cerberus-Remote function.
You will find more information about license keys in document
A6V10210362
.
See chapter 'Applicable documents'.
'Limited access (view only)'
In this operation mode, Cerberus-Remote indicates the same as the ↑ 'Station'
connected to it, but you cannot operate the linked 'Station'.
The figure in Cerberus-Remote indicates the display with all indicated texts, all
LEDs in their current state and all buttons.
'Full access (view/operation)'
In this operation mode, the connected 'Station' is visualized as in the 'Limited
access (view only)' operation mode. Additionally, the 'Station' can be operated with
Cerberus-Remote, while normal operation on the 'Station' is blocked, but can be
reactivated.
As operation on a
↑
'
Station
' must have priority, this restriction (blocking) on the
'Station' can be canceled at any time.
Each time an attempt is made to operate the ↑ 'Station', a window is displayed
with the option to abort the connection with Cerberus-Remote.
The LED test also tests the display. However, the LEDs are not displayed in
'Cerberus-Remote'.
You can configure a permanent authorization for
Cerberus
-
Remote
in
Cerberus
-
Engineering-Tool. You will find more information about this in document
A6V10210424.
See also
1 Enabling / Disabling Cerberus Remote [➙ 96]

Siemens FT724 Specifications

General

Brand	Siemens
Model	FT724
Category	Control Panel
Language	English