Siemens FT724 - Maintenance Command Group

Commands with required access levels
'Maintenance' command group
7
125 |
184
Building Technologies
A6V10211076_i_en_
--
Fire Safety
2015
-
12
-
15
7.6 'Maintenance' command group
Command Element category (short) Element category (long) Access level
Reset module Module Module 3
Accept replaced devices Line Line 3
Device replace mode ON Detect. Detector 2,2
Device replace mode OFF Detect. Detector 2,2
Read in installed devices Line Line 3
Remove/delete device Detect. Detector 3
Restart line Line Line 2,2
Auto-configure line Line Line 3
Calibrate Module Module 3
Enable sys.analyzer
access
Station Station 3
Disable sys.analyz. access Station Station 3
Enable MC link Station Station 2,2
Disable MC link Station Station 2,2
Remove loop extension Module Module 3
Enable full access C-Rem. Cerberus-Remote 2,2
Enable view access C-Rem. Cerberus-Remote 2,2
Disable access C-Rem. Cerberus-Remote 2,2
Delete event memory Station Station 3
Factory reset Station Station 3
Poll diagnostic data Line Line 2,2
Release FSD FSD FSD 3
Reset maintenance
reminder
Station Station 3
Scan for new modules Station Station 2,2
Accept Cerberus Mobile
client
Client Cerberus Mobile client 2,2
Remove Cerberus Mobile
client
Client Cerberus Mobile client 2,2
Show site ID Station Station 3
Lock FSD FSD FSD 3
Switch over CPU Module Module 3
Enable MC mode Device Device 2,2
Disable MC mode Device Device 2,2
Enable raw data logging,
set 1
Device Device 3
Enable raw data logging,
set 2
Device Device 3