Siemens FT724 - Entering the Configuration

Operation
Entering th
e configuration
5
92 | 184
Building Technologies
A6V10211076_i_en_
--
Fire Safety
2015
-
12
-
15
Selecting a 'Module' from a list
1. Continue without entering an address and confirm with <ok>.
 The list of all 'Modules' is displayed.
2. Select a 'Module'.
3. Press the 'Execute Commands' softkey.
 The 'Select command' window is open.
4. To display the software version, select 'Report SW version'.
– or
5. To display the hardware version, select 'Report HW version'.
 The selected 'Reports' are displayed.
6. Optional: To print out the 'Reports', select 'Print report'.
5.16 Entering the configuration
For example you can undertake the following settings in the menu 'Configuration':
● Switch 'Manned operation' / 'Unmanned operation'
● Set times for 'Unmanned operation'
● Set ↑ parameter sets for 'Manned operation' and 'Unmanned operation'
● Set customer text
Configuring the ↑ site
1. Select 'Main menu' > 'Functions'.
 The 'Functions' menu is open.
2. Select 'Configuration'.
 A list of all element categories on which a command of the 'Configuration'
command group can be executed is indicated.
3. Select the element category you want to configure.
 The 'Enter address' window is open.
4. Press <ok> without entering an address.
 A list with all elements is open.
5. Select an element and press <Softkey 1>.
 The 'Select command' window is open.
6. Select a command.
 The command is executed.