Siemens FT724 - Configuration Command Group

Commands with required access levels
'Report' command group
7
126 | 184
Building Technologies
A6V10211076_i_en_
--
Fire Safety
2015
-
12
-
15
Command Element category (short) Element category (long) Access level
Enable raw data logging,
set 3
Device Device 3
Disable raw data logging Device Device 3
Enable line diagnosis Line (C-NET) Line (C-NET) 2,2
Update incompatible
firmware
Station
Module
Submod.
Phys.ch
Station
Module
Submodule
Physical channel
3
Auto-configure station Station Station 3
Show unconfigured
devices
Line Line 2,1
Freeze selected outputs
ON
Station
Module
Line
Station
Module
Line
3
Freeze selected outputs
OFF
Station
Module
Line
Station
Module
Line
3
7.7 'Report' command group
Command Element category (short) Element category (long) Access level
Report SW version Station
Module
Line
Station
Module
Line
2,1
Report HW version Station
Module
Line
Station
Module
Line
2,1
7.8 Other commands
Command Element category (short) Element category (long) Access level
START LED test Module Module 2,2
END LED test Module Module 2,2
Initiate display test Line Line 2,2
Set system time Line Line 2,1