Switching off / Switching on
5
54 | 184
↑ Switching off ↑ 'RT Fire'
1. Select 'Main menu' > 'Topology'.
The three partial topology trees are listed.
2. Select ↑ 'Control tree'.
The 'Select element category' window is open.
3. Select the 'Alarmg.' list item.
The 'Elements' window is open.
4. Select 'Alarmg. 2' and press 'Execute Commands' <softkey 2>.
The 'Select command' window is open.
5. WARNING! When the remote transmission Fire has been switched off, the
fire brigade cannot be called up in the event of fire! Select the 'RT FIRE
channels OFF' command and press <ok>.
The command response confirms that the command has been executed.
The 'RT Fire' is switched off.
The LED 'Remote alarm Off' on the ↑ Person Machine Interface is illuminated.
LED statuses:
● Off
● Steady on with isolation
● Flashing with fault
Example of ↑ switching off 'RT Fire' using 'Topology' main menu
item:
Topology
Exit with <C>
Access level 2.1
↑ Detection tree
Hardware tree
↑ Control tree
(1)
(2)
(3)
Function
On/Off
Function
All
LED
test
κ Select 'Control tree', continue with <ok>
003 Elements Control tree
Evac gr
Alarmg.
Fire gr
2
2
3
Evac control groups
Standard alarming controls
Elevator control
Lower
level
Execute
Commands
κ Select 'Alarmg.', continue with <ok>
To Next Page
Loading...
Need help?
General
