Starting the Programming Mode
Operation For internal distribution only
A31003-K1250-S100-12-7619
6-16 HiPath 1100, Service Manual
Windows ME
1. The Add New Hardware Wizard window appears. A message will appear indicat-
ing that Setup will search for new drivers for the HiPath 1000. Choose "Specify
the location of the driver (Advanced)" and click "Next."
2. Select the option "Search for the best driver for your device (Recommended)."
3. Select the “Specify a location:“ checkbox and click “Browse“ to select the direc-
tory where the uncompressed CallBridge for Data is stored (e.g., C:\Temp).
4. Click "Next" to proceed.
5. A message will appear indicating that Setup will search for a driver for CallBridge
for Data (Eval). Click "Next" to proceed.
6. A message appears confirming that the CallBridge for Data (Eval) installation was
completed. Click "Finish."
7. A message will appear indicating that Setup will search for a driver for the HiPath
1000. Repeat hardware driver installation (steps 1 through 6) for the following
components:
● HiPath 1000 Virtual COM Port
● HiPath 1000 (CAPI Interface).
Figure 6-9 Windows ME - Specify installation folder
Figure 6-10 Windows ME - USB/CAPI driver installation location
To Next Page
Loading...
