Starting the Programming Mode
Operation For internal distribution only
A31003-K1250-S100-12-7619
6-30 HiPath 1100, Service Manual
Examples:
1. Internal call from Extension 16 to the VMIe Group: ***1***16*1
2. Direct internal call from Extension 15 to Extension 11, forwarded (*11) to the
VMIe Group: ***3****15****11*1
3. Direct internal call from Extension 11 to Extension 15, forwarded to the VMIe
Group configured as second Attendant. ***4****11****15*1
4. Incoming call over an external analog line to Extension 11, forwarded (*11) to the
VMIe Group: ***3**********11*3
5. Incoming call over an external digital line to Extension 11, forwarded (*11) to the
VMIe Group: ***3**********11*4
6. Incoming call over an external analog line to Extension 12, forwarded to the VMIe
Group configured as second Attendant. ***4**********12*3
7. Incoming call over an external digital line to Extension 12, forwarded to the VMIe
Group configured as second Attendant. ***4**********12*4
2
Calling Extension
Required item
Fixed size: 6 DTMF signals
Format: “****I” (I = calling extension)
External call format: always “******”
Note: If the extension number is longer, the DTMF digit “*” in the protocol is replaced
by the extension’s additional digit.
3
Extension called
Required for all Type 3 and 4 calls
The item remains empty for all other types of calls
Fixed size: 6 DTMF signals
Format: “****I” (I = extension called)
Note: If the extension number is longer, the DTMF digit “*” in the protocol is replaced
by the extension’s additional digit.
4
Additional information about the calling extension
Optional item
Fixed size: 2 DTMF signals
Format: “*I” (I = code in table below)
Code Information
1 The Calling Extension is a standard internal extension
2 Not used
3 The Calling Extension is an external caller on an analog line
4 The Calling Extension is an external user on a digital line
To Next Page
Loading...
