Comments about the System’s Programming Codes
Configuring the System Specifically for the Client For internal distribution only
A31003-K1250-S100-12-7619
7-36 HiPath 1100, Service Manual
Deleting digits from the Caller List (71)
Specifies the digits that do not need to be repeated when making a call.
Date/Time - Manual Setting (14)
Sets the current Date and Time for the system. When the default configuration is re-
stored (99), the Date setting displays information about the date the software was
create and will display the time as 12:00.
Updating Date/Time over an ISDN Line (038)
This setting allows automatic synchronization of the system’s date and time during
an external call over an ISDN line.
Call Charge Unit (95)
This setting specifies a Call Charge Factor used as a multiplier for the number of puls-
es so that call charges can be displayed in currency units.
Multiple for Call Charge Factor (042)
This setting specifies the multiplier for Call Charge factors. The default setting spec-
ifies that each pulse be multiplied by 1 for both factors.
Call Charge Factor for extensions (043)
This setting specifies whether the extension should be assigned a rate schedule and,
if so, which Factor should be used to calculate call charges.
Call Charge Value by Extension (97)
This setting specifies the amount that can be spent by each extension.
Call Cost Limit by Extension (044)
This setting limits the amount available to an extension for Call Charges.
Date for Updating the Call Cost Limit for an Extension (045)
This specifies a day for resetting the Call Charge limit.
Setting a System Password (80)
Changes the default password 31994 to any 5-digit number you select (see“Issues
Concerning Changes to the Default Password” on page 6-3).
Night Service Password (49)
Defines an additional password for activating/deactivating different functions (includ-
ing Relays, Night Service).
To Next Page
Loading...
