Comments about the System’s Programming Code
A31003-K1250-S100-12-7619
HiPath 1100, Service Manual
7-37
For internal distribution only Configuring the System Specifically for the Client
Restoring Default Settings (99)
Restores all default factory settings. After entering this code, the system will restart.
Only the settings for Country/Group of Countries (Code 65) will be saved as last con-
figured.
Regular Timers and System Timers (39 and 40)
These settings allow you to reset the times for some features and signals according
to the specific characteristics of a user or a country.
DTMF signals for the Relay (77)
When an alarm is triggered, the HiPath 1120 makes a call using the Speed Dialing en-
try 249. The slot number is called and a sequence of digits in DTMF format is repeat-
ed every 5 seconds immediately after the connection is established. This sequence
of 25 digits is used to determine the source of the alarm so that an alarm exchange,
for example, can identify from which PABX the alarm is coming from. If the receiving
exchange does not acknowledge the alarm within 1.5 minutes, the procedure is re-
peated every 3 minutes.
Emergency Numbers (040)
You can specify up to five emergency numbers. When one of these numbers is dialed
and all external lines are busy, the call on the first external line will be interrupted and
the line used for making the emergency call. A call is not disconnected when it is an
incoming call over an external analog line.
Module Detection (061)
This setting specifies the slots to which new modules are connected, so that the sys-
tem may detect them.
The modules can only be connected/disconnected when the system is turned off.
For more details on how to set timers refer to the Help file of the HiPath 1100 Man-
ager administrative software. See the sections on timers specifically.
The name assigned to these numbers can have up to 15 characters.
Emergency calls never use external lines configured for:
● Internet access
● An absent external line
● An external line configured to accept only incoming calls
To Next Page
Loading...
