Siemens SIMOTION

Configuring the Path Object
3.5 Assigning path object parameters/default values
TO Path Interpolation
Function Manual, 11/2010
89
Field/button Meaning/Instruction
Mode of path-synchronous
motion
Here, you specify the synchronous axis mode:
 Absolute
 Relative
 Output path lengths
 Additive output of path lengths
(userDefault.w.mode)
See Functionality of path-sync
hronous motion (Page 40).
Blending Here, you specify whether and how blending is performed.
(userDefault.blendingMode)
See Path behavior at motion end (Page 36).
Construction point mode Center point or intermediate point:
 Absolute
 Relative
 Same as target position mode
(userDefault.path.ijkMode)
See Circular paths (Page 22).
Note:
Transformations are set using the expert list.
(See Motion Control Basic Functions, "Expert list")
For additional information, see Basics of Path Interpolation (Page 15).
The mea
ning of the dialog wind
ow parameters and their permissible value ranges can be
found in the SIMOTION reference lists.