Setup
3.1 Punching and nibbling tools
3-35
SINUMERIK 802D sl Operation and Programming Nibbling (BP-N), 06/2006 Edition
6FC5 398-3CP10-0BA0
Table 3-1 Parameters of the tool list, continued
Field Description
Type Describes the type of the tool geometry:
1 Round tool
2 Rectangular tool
3 Triangular tool
4 Double “D”
5 Single “D”
6 Long “D”
7 Elongated hole
8 Hexagon tool
9 Octagon tool
99 Free geometry
104 Multi-tool, 4 punches
105 Multi-tool, 5 punches
106 Multi-tool, 6 punches
108 Multi-tool, 8 punches
109 Multi-tool, 9 punches
110 Multi-tool, 10 punches
111 Multi-tool, 11 punches
112 Multi-tool, 12 punches
Dimension 1 Radius or length of the cutting edge
Dimension 2 Width of the cutting edge
Sheet thickness Maximum sheet thickness which can be machined
If the technology setup has not been read in by the toolbox or the wrong technology setup
has been read in, it might be that the supplementary tool parameters for the Nibbling con-
figuration are not yet activated. This is displayed to the operator.
Fig. 3-2 Message in case of a configuration error
To open the complete parameter list, use <Advanced>.
To Next Page
Loading...
