Siemens TM SIWAREX WP351 HF User Manual

6.21.2 Log single loadings (OIML R-107) [logSingleLoadings]
The parameter defines whether single fillings of a load are logged in THW mode in addition to
the master totalizer.
If single fillings of a load are logged, the single fillings are permanently labeled with the string
"delta n", whereby 'n' stands for the number of the current single filling.
The legal-for-trade accumulated total is labeled "T1" and is stored with the set string 1, 2, 3 or
4 in the alibi memory. Not legal-for-trade loggings of the total T1 (e.g. T1 < Minimum totalized
load (DR3)) are labeled "t1" in the protocol memory.
The measured actual weights are logged in CW mode.
6.22 DR29 Configuration of technology messages
Introduction
In DR29, it is possible to suppress the technology messages from the electronic weighing
system in a targeted manner as described in section Technology messages (Page 131).
Web server procedure
1. Read DR29.
2. Select "No message" for the desired technology messages.
3. Write DR29.
TIA Portal procedure
1. Read DR29: Command code 2029.
2. Enter "false" for the desired technology messages.
3. Write DR29: Command code 4029.
6.23 DR30 Read out process state
6.23.1 Overview
Internal states and process values of the scale can be monitored using the process values. This
data is not required for standard operation of the scale.
The monitoring of selected data during trial operation is extremely useful as it helps you to
optimize parameters and locate errors.
DR30 contains all weight values and related status information of the electronic weighing
system. All values are read-only. You can find the status information in the parameter table
Parameter assignment/addressing
6.23 DR30 Read out process state
Technology module TM SIWAREX WP351 HF
Operating Instructions, 01/2020, A5E47521010-AA 103

Siemens TM SIWAREX WP351 HF Specifications

General

Brand	Siemens
Model	TM SIWAREX WP351 HF
Category	Control Unit
Language	English