Parameter Add info [errorAddInfo]
Modbus TCP Port number connection 2 789
Modbus settings connection 2 790
Enable connection 791
Byte swap for text fields 799
Byte swap for 16 bit tags 800
Byte swap for 32 bit tags (1 # 2, 3 # 4) 801
Word swap for 32 bit tags (1, 2 # 3, 4) 802
I/O process value 1 807
I/O process value 2 808
I/O process value 3 809
I/O process value 4 810
I/O process value 5 811
I/O process value 6 812
I/O process value 7 813
I/O process value 8 814
Event hardware interrupt 4 815
Event hardware interrupt 5 816
Event hardware interrupt 6 817
Event hardware interrupt 7 818
Event hardware interrupt 8 819
RS485 protocol 820
Source for weight simulation 821
9.4.7 Add info [errorAddInfo] for DR10
Table 9-6 Add info [errorAddInfo] for DR10
Parameter Add info [errorAddInfo]
Load cell type 1001
AD converter settings 342
Power line frequency 343
Power line filter 344
Load cell parameter 1003
Connection technology 1004
External / internal sensor supply 1005
No. of mechanical support points 1020
Averaged load cell characteristic (mV/V) 1021
Nominal load of one single load cell 1022
Impedance reference (Ohm) 1023
Maximum impedance deviation (% of impedance reference) 1024
Stringheader load cell manufacturer 1026
Load cell manufacturer 1027
Interrupts/diagnostic messages
9.4 Operating errors
Technology module TM SIWAREX WP351 HF
Operating Instructions, 01/2020, A5E47521010-AA 141