Siemens TM SIWAREX WP351 HF User Manual

Parameter Add info [errorAddInfo]
Bitfield: Controller settings 2408
Controller behavior in case of exceeding max. control access 2409
Intervention of fine time controller 2410
Set point fine time controller (s) 2430
Adopt corrected fine-/trailing values to DR23 automatically 2431
Max. control access of fine time controller 2433
9.4.9 Add info [errorAddInfo] for DR25 and DR28
Table 9-8 Add info [errorAddInfo] for DR25 and DR28
Parameter Add info [errorAddInfo]
Maximum single set point 2501
Minimum automatic tare weight (% of max.) 2502
Maximum automatic tare weight (% of max.) 2503
Maximum weighing time (s) 2504
Reserve (for continuous mode, only relevant for GFI, is now triggered
via commands)
2505
Weighing start options 2506
Cycle time for automatic zero setting (s) 2507
Number of weighings without automatic taring/zero setting 2508
Bitfield: Test stops 2509
Check stop after step 0 2510
Check stop after step 1 2511
Check stop after step 2 2512
Check stop after step 3 2513
Check stop after step 4 2514
Check stop after step 5 2515
Check stop after step 6 2516
Check stop after step 7 2517
Delete tare in weighing step 0 2529
Automatic discharging 2544
Discharge time (s) 2545
Discharge overlapping time (s) 2546
Maximum discharge time (s) 2547
No. of optimized loadings (OIML R-107) 2552
Dosing signals during extra coarse phase 2554
Dosing signals during coarse phase 2555
Additional string Stringheader 2801
Additional string 2802
Protocol settings 2803
Log with additional string 2804
Interrupts/diagnostic messages
9.4 Operating errors
Technology module TM SIWAREX WP351 HF
Operating Instructions, 01/2020, A5E47521010-AA 143

Siemens TM SIWAREX WP351 HF Specifications

General

Brand	Siemens
Model	TM SIWAREX WP351 HF
Category	Control Unit
Language	English