Siemens TM SIWAREX WP351 HF User Manual

Parameter Add info [errorAddInfo]
Stringheader load cell order number 1028
Load cell order number 1029
9.4.8 Add info [errorAddInfo] for DR20 to DR24
Table 9-7 Add info [errorAddInfo] for DR20 to DR24
Parameter Add info [errorAddInfo]
Set point 2001
Total set point 2101
Maximum allowed total set point undercut 2102
Material in feed intake (pre-signal) 2103
Tolerance relation 2201
Tolerance limit TH2 2203
Tolerance limit TH1 2204
Tolerance limit TL1 2205
Tolerance limit TL2 2206
Behavior in case of TH1 error 2208
Behavior in case of TL1 error 2209
Pulse duration for pulse post dosing (s) 2211
Number of unchecked weighing cycles 2212
Capture of weighings into statistics 2213
Parameter relation 2301
Fine weight 2305
Trailing weight fine 2306
Blocking time coarse signal (s) 2307
Blocking time fine signal (s) 2308
Blocking time discharging (s) 2309
External triggered blocking time (s) 2310
Shut-off correction weight 2311
Trailing weight coarse 2312
Minimum material flow (weight/s) 2313
Coarse weight 2317
Blocking time extra coarse (s) 2318
Trailing weight extra coarse 2320
Parameter relation 2401
Type of controller 2402
Control factor of proportional controller (%) 2403
Control factor of fine time controller (%) 2404
Max. control access of proportional controller 2405
Proportional controller deadband - upper limit 2406
Proportional controller deadband - lower limit 2407
Interrupts/diagnostic messages
9.4 Operating errors
Technology module TM SIWAREX WP351 HF
142 Operating Instructions, 01/2020, A5E47521010-AA

Siemens TM SIWAREX WP351 HF Specifications

General

Brand	Siemens
Model	TM SIWAREX WP351 HF
Category	Control Unit
Language	English