Siemens TM SIWAREX WP351 HF User Manual

6.30 DR47 Read out logbook content
Changes to the used software version of SecureDisplay of the legal-for-trade main display
[HMI] and changes to the firmware of the electronic weighing system are recorded in the
logbook.
Scrolling in the logbook is possible using commands 881 to 883.
Legal-for-trade reading of the logbook is carried out using the SecureDisplay legal-for-trade
main display. Non-legal-for-trade reading is carried out using DR47.
6.31 Commands
6.31.1 Overview
The commands for the electronic weighing system described here can be transmitted by the
following interfaces:
● From the SIMATIC HMI via the SIMATIC controller to the electronic weighing system
● From the SIMATIC HMI directly to the electronic weighing system via Modbus
● From the web server directly to the electronic weighing system
● Via the digital inputs after corresponding assignment in data record DR07
If an issued command is not accepted by the electronic weighing system, the cause of the
rejection is always substantiated with a corresponding data/operating error.
Detailed descriptions of the commands can be found in the following tables:
→ Table 6-3 Service commands (Page 112)
→ Table 6-4 Protocol commands, statistics, logbook (Page 113)
→ Table 6-5 Trace commands (Page 113)
→ Table 6-6 Totalization commands (Page 114)
→ Table 6-7 Display changeover for DR34 and SecureDisplay (Page 114)
→ Table 6-8 Scale commands (Page 115)
→ Table 6-9 Weighing commands (Page 116)
See also
Commands (Page 112)
Parameter assignment/addressing
6.31 Commands
Technology module TM SIWAREX WP351 HF
Operating Instructions, 01/2020, A5E47521010-AA 111

Siemens TM SIWAREX WP351 HF Specifications

General

Brand	Siemens
Model	TM SIWAREX WP351 HF
Category	Control Unit
Language	English