Siko AG06 User Manual

Display and Control Keys
AG06 Date: 07.02.2018 Art. No. 85674 Mod. status 055/18 Page 7 of 114
3 Display and Control Keys
3.1 General
The actuator has a two-line display with special characters and three control keys. The keys
serve for actuator parameterization and control. Two LEDs (1, 2) inform about the actuator's
operating state.
Fig. 2: Control elements
3.2 LCD display
With supply voltage applied to the control, the actual value is displayed in the first line and
the set point value with factory settings in the second line.
The value displayed in the 2
nd
line can be adjusted via parameters.
3.3 LED displays
LED
Colour
State
Description
LED1
green
on
Actuator is within the programmed position window.
Supply voltage of the output stage is applied.
blinking
Actuator is within the programmed position window.
Supply voltage of the output stage is missing.
off
Actuator is outside the programmed position window.
red
on
Actuator is outside the programmed position window.
Supply voltage of the output stage is applied.
blinking
Actuator is outside the programmed position window.
Supply voltage of the output stage is missing.
off
Actuator is within the programmed position window.
LED2
orange
blinking 2.5 Hz
NMT state: 'PRE-OPERATIONAL'
on
NMT state: 'OPERATIONAL'
blinking pulse-
duty factor 1:5
off
NMT state: 'STOPPED'
Table 1: LED displays
LED2
LED1
LCD display
Keys

Siko AG06 Specifications

General

Brand	Siko
Model	AG06
Category	Controller
Language	English