Siko AG06 - Inching 2 Offset; 2451: Type of Acceleration Inching Mode 2; Production Date

Communication via CAN bus
AG06 Date: 07.02.2018 Art. No. 85674 Mod. status 055/18 Page 107 of 114
9.13.2.50 2450
h
: Inching 2 Offset
An offset value can be set in inching operation 2 via object 2450
h
.
Sub-index
00
h
Description
Offset value in inching operation 2 (see chapter 8: Parameter description
 Parameter no. 30)
Access
read-write (recordable in the "Pre-Operational" and "Operational" states)
PDO mapping
no
Data type
Unsigned8
Default
100
EEPROM
no
Value range
10 … 100
9.13.2.51 2451
h
: Type of acceleration Inching mode 2
The type of acceleration can be set in inching operation 2 via object 2451
h
.
Sub-index
00
h
Description
Type of acceleration in inching operation 2 (see chapter 8: Parameter
description  Parameter no. 31)
Access
read-write (recordable in the "Pre-Operational" and "Operational" states,
cannot be written with active travel job)
PDO mapping
no
Data type
Unsigned8
Default
0
EEPROM
yes
Value range
0 … 1
9.13.2.52 2500
h
: Production Date
Object 2500
h
indicates the production date.
Sub-index
00
h
Description
date of productionin readable hex notation (see chapter 8: Parameter
description  Parameter no. 58)
Access
read-only
PDO mapping
no
Data type
Unsigned32
Default
no
EEPROM
yes
Format description (example):
15 07 20 09
h
= 15.07.2009 = DDMMJJJJ