Simplex 4007ES - Page 46

6-10
4007ES Panel Programmer Manual (579-1167)
Editing Standard Component Properties, Continued
Editing the NAC
Power Supply
To edit the NACs tab (Figure 6-15):
1. Select a circuit to configure in the table.
Figure 6-15. NAC - NACs Tab
2. Select a point type from the Point Type drop-down list.
3. Enter a custom label.This label should make the point easily identifiable.
4. Select the EOL resistance from the EOL Resistance drop-down list.
5. Click Apply > OK to confirm the edits.
To edit the AuxNAC tab (Figure 6-16):
1. Select a circuit to configure in the table.
Figure 6-16. NAC - AuxNAC Tab
2. Select a point type from the Point Type drop-down list.
3. Enter a custom label. This label should make the point easily identifiable.
4. Click Apply > OK to confirm the edits.