Sindoh M401 - Page 103

A : LSU unit
C : Assembly knob (cam format)
B : BLACKET STAY : LSU
1. Put ‘1’ hole on ‘A’ to ‘1’ EMBO shape on ‘B’
2. Put bump on ‘C’ floor through ‘2’ shape on ‘A’ to ‘2’ hole on B
3. Rotate ‘C’ to circumferential direction to match the end of the arrow on the bottom of ‘C’ with ‘+’
hole around ‘2’ hole on B.
4. Lock a washer bolt on ‘3’ position.
5. Lock a washer bolt on ‘4’ position.
6.
Lock a washer bolt on ‘5’ position.
7. Remove ‘C’.
<MF/HF MODEL>
A : Laser Unit
C : Skew Adjusting JIG (cam format)
B : BKT STAY LSU
1. Put ‘1’ hole on ‘A’ to ‘1’ EMBO shape on ‘B’
2. Put bump on ‘C’ floor through ‘2’ shape on ‘A’ to ‘2’ hole on B
3. Rotate ‘C’ to circumferential direction to match the end of the arrow on the bottom of ‘C’ with ‘+’
hole around ‘2’ hole on B.
[ A ]
1
2
[B ]
[C]
‘+’ Hole on C