When scanning: There’s not enough memory to use for scanning. Pressing start key will initiate
initialization.
USB Device (PC Connection) and Host (USB Memory)
When USB Memory Print/Scan is tried, but there’s no USB or not recognized.
Check if USB is mounted properly and retry it after 5 seconds. USB memory
formatted with some special partition cannot be used.
It occurs when an error occurred while creating a file on USB memory scan
Please check USB memory’s remain capacity.
It occurs when USB cable was pulled out and disconnected during a USB
cable using scanning. Please check cable connection and press Start key for
initialization.
Fatal SW Error
Internal SW execution problem has occurred. There’s a high possibility of having damaged flash
memory’s file data and normal system operation is not possible. Replace system card if code
update is performed, but cannot be solved.
Most of paper jams occur by inappropriate print paper or incorrect paper loading.
If a paper jam message is displayed from a paper jam, all the papers jammed on the entire path must be
eliminated to remove the message
The following figure displays the paper’s internal path. Paper path varies by the tray (copy tray, option
tray and bypass tray) and paper discharge direction. See the “Paper Jam Message” described above for
details.
To Next Page
Loading...
