Skycut D Series - Page 32

32
(11) Change the Cut Line Type to Draw (Pen):
(12) In Section 1.11 you installed the Skycut in SCAL. To now open the Cut Settings window, either:
• Go to Cutter> Cut with Skycut
• Click on the Cutter icon at the top
(13) The follow window opens:
Change your
settings to the
ones shown
here
Preview of shape and
where it will cut
Communication
settings
Click here to cut design with these settings
Click on the wrench icon
(Style Panel
)
Click on the arrow layer on the
Layers Panel
Change to Draw (Pen)