The Snap-on® Cloud Registration - Getting Started
155
16.3.2 Snap-on Cloud - ShopKey Pro and SureTrack
User Setup
z If you already have a ShopKey Pro or SureTrack account, follow these
steps to register and setup your Snap-on Cloud account:
From a PC or mobile device:
1. Connect the diagnostic tool to a Wi-Fi network, see Wi-Fi Connection /
Troubleshooting on page 147.
2. Write down the Serial Number, PIN and Code that are displayed when the
device connects to the Wi-Fi network (Figure 16-2), or leave the screen
displayed. Registration information can also be found in the Tools menu, see
Snap-on Cloud Setup Information Screen on page 156.
Figure 16-2
The PIN and Code numbers will change each time you view the Setup screen
(Figure 16-3 and Figure 16-2). This is normal, any displayed set of PIN and
Code numbers may be used to register.
3. Using a mobile device or PC, visit https://ALTUSDRIVE.com and select Login
(upper right screen).
4. Log in using your ShopKey Pro or SureTrack Username and Password.
5. Open the Profile Manager (additional login may be required).
6. From the Device Management tab, select Add Device.
7. Enter your Serial Number, PIN, Code, and Device Name.
8. Log out of Profile Manager, then select the ALTUS Home Page browser tab to
get started.
9. Turn the diagnostic tool off, and then on.
10.See Using the Snap-on Cloud.
Your Diagnostic diagnostic tool is now registered to your Snap-on Cloud account.
Code scan reports will be automatically sent (only when connected to Wi-Fi) to your
online account from the device.
If the device is not connected to a Wi-Fi network when the code scan is
performed, it will not be sent to the account. Wi-Fi connection is required to
upload the report to The Snap-on Cloud.
To Next Page
Loading...
Need help?
General
