98 Service Manual
7 Settings Import/Export
7.4.2 Importing Probe Table File
You can import the engineering probe table to replace all engineering probe tables in the system.
1. Back up the engineering probe table into the root directory of the USB drive, and ensure
its version is consistent with the version of system engineering probe table. Otherwise, the
performance may fail with a prompt Wrong Version.
2. Connect the USB drive to the ultrasound system.
3. Enable the touch-screen keyboard, tap Shift, E and press the Menu key successively. Type the
month password in the pop-up dialogue box, and then press the Enter key to confirm.
4. Select Probe Table In, and press the Set key to back up the probe table into the USB drive. A
prompt Successful is displayed to indicate the probe table is successfully backed up.
NOTE:
● Keypass and probe table are written in by selecting
Probe Table In
, and writing in keypass
file owns a higher priority. Therefore, ensure no keypass file and only one
userdataX.X.X.X.-
oo.tar.gz
file are in the USB drive before you import probe table. Otherwise, a failure import
may result or the imported file cannot be recognized.
● Only the engineering probe table configuration can be imported to the ultrasound system.
Take notice of probe table configuration in the ultrasound system before the import. The
probe table import/export is only available between same system models, equivalent system
models for human and veterinary usages, or same system models with and without dongles.
To Next Page
Loading...