Field
Frequency (Optional)
(Only visible if Frequency Swap
License is loaded)
Radio Region used for DECT communication with
handsets.
With the Frequency Swap License installed, it is pos-
sible to perform frequency swap between handsets.
Besides the Frequency Swap License, a special Spec-
tralink DECT Handset 7212 (part no. 02610004) with
a special configuration (and compliance to be com-
patible with frequency swap) is also required.
Possible values:
l Europe (EMEA, Australia & NewZealand)
l South America
l USA (USA & Canada)
When the frequency of the base stations is changed,
handsets loose the signal from the base stations.
Then, after a while, the handsets will try to find base
stations (with same ARI – System ID) on the other fre-
quency band. The server must be restarted after chan-
ging frequency.
Note: It is possible to change the frequency setting in
the server using OAM-REST API. For more inform-
ation, see "OAM REST API" on page275.
For more information about frequency swap and the
special Spectralink DECT Handset, see "Frequency
Swap Support" on page281.
Allow bearer handovers to repeat-
ers (Optional) (Not relevant to the
Spectralink IP-DECT Server
200/400)
If enabled, bearer handover to repeaters is allowed.
If disabled, handovers between a repeater and base
station must take place as connection handovers.
Default value: Enabled
Note: If Zone based paging is used, then bearer han-
dover is not allowed, and this setting is overruled.
Wireless Server Configuration - Media resources (Not relevant to the Spectralink IP-
DECT Server 200/400)
Allow new (Optional) If enabled, new media resources are allowed to con-
nect to the server.
Default value: Enabled
To Next Page
Loading...
