14215700-IG, Edition 15.0
May 2020, Original document
245
To Update Spectralink IP-DECT Base Station Firmware
Note:
Not relevant to the Spectralink IP-DECT Server 200.
New firmware can be uploaded either through provisioning (license required) or manually.
Note:
Base stations can use default firmware, if selected when server firmware is uploaded.
For more information, see "To Update Spectralink IP-DECT/Virtual IP-DECT Server
Firmware" on page243.
Note:
Automatic update of Spectralink IP-DECT Base Stations requires base stations with firm-
ware version PCS 15__ or newer.
1. Click Firmware, and then click Base Station.
2. On the Update base station firmware page, enter the following data:
Field Setting
Update base station firmware - Default
Information about default firmware files type, version (PCS)
and build number - if firmware files have been uploaded.
Note: Once uploaded, default firmware will remain on the
server until overwritten.
Note: If the Use firmware as default check box on the
Update firmware page is enabled (Firmware > Wireless
Server or Configuration > Provisioning > Firmware), then
the server firmware is uploaded as default for all base stations
and media resources (recommended). For the files to be
updated in the base station, this must be executed either
through manual update or automatic update.
Spectralink IP-DECT Server 200/400/6500 and Virtual IP-DECT Server One Installation and Configuration Guide
To Next Page
Loading...
