14215700-IG, Edition 15.0
May 2020, Original document
419
Field Setting
Firmware file (Optional) The firmware file can be either a previously uploaded default
firmware file, or a new firmware file chosen. A new firmware file
has to be a valid firmware file with the extension .bin or a zip file
containing a valid firmware file.
Select either Default or Upload.
Note: Zip file firmware update is only supported on systems run-
ning firmware PCS 20B_ or newer.
Start media resource No The index number of the first media resource to be updated.
You can check media resource numbers under Admin-
istration > Media resource.
End media resource No The index number of the last media resource to be updated.
Firmware - Base Station
Field Setting
Update base station firmware - Default
Information about default firmware files type, version (PCS)
and build number - if firmware files have been uploaded.
Note: Once uploaded, default firmware will remain on the
server until overwritten.
Note: If the Use firmware as default check box on the
Update firmware page is enabled (Firmware > Wireless
Server or Configuration > Provisioning > Firmware), then
the server firmware is uploaded as default for all base stations
and media resources (recommended). For the files to be
updated in the base station, this must be executed either
through manual update or automatic update.
Spectralink IP-DECT Server 200/400/6500 and Virtual IP-DECT Server One Installation and Configuration Guide
To Next Page
Loading...
