SpectraLink IP-DECT SERVER 6500 - Service Codes - Spectralink IP-Dect;Virtual IP-DECT Server

14215700-IG, Edition 15.0
May 2020, Original document
46
Service Codes - Spectralink IP-DECT/Virtual IP-DECT
Server
It is possible to access the Spectralink IP-DECT/Virtual IP-DECT Server in operation using a hand-
set.
Use any handset and enter ***999* followed by a 2-digit code for the information you wish to
retrieve, and then press off-hook.
Access basic information such as:
l IP address - enter ***999*00
l MAC address - enter ***999*01 (not relevant to Spectralink Virtual IP-DECT Server One)
l Server firmware ***999*02
Note:
If UPnP is enabled, all Spectralink IP-DECT/Virtual IP-DECT Servers can be identified
on the network by their serial number/UUID. For more information, see "Discovering
Spectralink IP-DECT/Virtual IP-DECT Components on the Network" on page119.
The serial number can be found on the label on every Spectralink IP-DECT/Virtual IP-
DECT Server. For more information, see "Identifying ARI on Spectralink IP-DECT/Vir-
tual IP-DECT Server" on page69.
Spectralink IP-DECT Server 200/400/6500 and Virtual IP-DECT Server One Installation and Configuration Guide