14215700-IG, Edition 15.0
May 2020, Original document
248
To Update Spectralink DECTMedia Resource/Spectralink Virtual IP-DECT Media
Resource Firmware
Note:
Not relevant to the Spectralink IP-DECT Server 200/400.
Once uploaded, default firmware will remain on the server until overwritten or deleted. New firmware
can be uploaded either through provisioning (license required) or manually.
Note:
Media resources can use default firmware, if selected when server firmware is uploaded.
For more information, see "To Update Spectralink IP-DECT/Virtual IP-DECT Server
Firmware" on page243.
1. Click Firmware, and then click MediaResource.
2. On the Update media resource firmware page, enter the following data:
Field Setting
Update media resource firmware - Default
Information about default firmware files type, version (PCS)
and build number - if firmware files have been uploaded.
Note: Once uploaded, default firmware will remain on the
server until overwritten.
Note: If the Use firmware as default check box on the
Update firmware page is enabled (Firmware > Wireless
Server or Configuration > Provisioning > Firmware), then
the server firmware is uploaded as default for all base stations
and media resources (recommended). For the files to be
updated in the media resource, this must be executed either
through manual update or automatic update.
Spectralink IP-DECT Server 200/400/6500 and Virtual IP-DECT Server One Installation and Configuration Guide
To Next Page
Loading...
